Tensioning the Top Thread

Tensioning the Top Thread

Good tension means your top and bobbin threads meet right in the middle of the quilt. When they're balanced, your stitches look great on both sides.

Before You Begin

Always set your bobbin tension first. If you haven't yet, start with our Bobbin Basics video.

Then, check your top thread. Give it a gentle pull. It should feel smooth, with a little resistance. If it slides through too easily, rethread.

What You'll Need

You'll need a scrap of solid fabric that contrasts with your thread, so your test stitches stand out. Lay it on the extra batting and backing along the edge of your quilt. That way, you can test without stitching into your project.

Tip: While you're learning, match your top and bobbin thread colors.

Test, Check, Adjust

1. Stitch a test

Stitch a few small loops and a quick zigzag. Those curves and points will show tension problems that a straight line might hide.

2. Check both sides

Now check both sides.

  • Bobbin thread showing on top? Your top tension is too tight.
  • Top thread pulling through to the back, with little eyelashes on the curves? It's too loose.

3. Adjust the top tension

To adjust, turn the tension dial clockwise to tighten or counterclockwise to loosen. Make small adjustments and test again.

4. Test again

Keep adjusting until both sides look the same. It's normal for this to take a few tries.

Tip: Big loops or a tangle on the back usually mean your thread slipped out of the tension discs. Rethread, then test again.

Ready to Quilt

Your tension is balanced, and you're ready to quilt. Just run a quick test any time you change threads.