Let's install your ruler base, so your rulers have a steady, flat surface to stitch against.
Before You Begin
Before you begin, press Needle Up/Down to raise the needle.
Using a Studio3 or Gallery3 frame? Make sure it's set to ClearView before you install the ruler base or load your quilt.
What You'll Need
All you need is your Steady-Fit Ruler Base.
Install Your Ruler Base
1. Position the ruler base
Hold the ruler base by the front corners and tilt it down slightly. Line up the back hooks with the mounts on the machine. Then lower the front so the front hooks line up with the front mounts.
2. Push it into place
Push the ruler base back until it's snug against the machine.
3. Remove the ruler base
When it's time to take it off, grasp the front corners, pull toward you, and lift it away.
Use Compatible Rulers
Only use quarter-inch-thick longarm rulers. Rotary-cutting rulers are too thin and can slip under the hopping foot.
Ready for Ruler Work
You're all set. Grab a longarm ruler and give it a try.