For best results, start every new project with a fresh needle. Follow along with the video, or use the written steps below while you change your own.
Before You Begin
Press the Needle Up/Down control to raise the needle, then turn off all power to the machine.
What You'll Need
Grab the hex wrench that came with your machine, a fresh pack of needles, and something to put your old needle in.
- 2.5 mm hex wrench
- New needle (size depends on your thread weight)
- A magnetic tray or other spot for the old needle
Change Your Needle
1. Remove the old needle
Insert your wrench and loosen the clamp screw counterclockwise. Don't remove the screw entirely — just loosen it enough to let the old needle drop out.
Set it aside — we'll use it to help align the new needle.
2. Identify the front and back of the new needle
Grab a fresh needle, locate the scarf, and rotate the needle so the scarf faces the back. The groove should face the front.
- Long groove: faces the front
- Scarf: the indent on the back of the needle, by the eye
3. Insert the new needle fully
With the groove facing forward, push the new needle straight up until it stops. Look into the sight hole above the screw — the top of the needle must be fully visible.
4. Check the needle alignment
Slide the tip of your old needle down the front groove and into the eye. Use it as a small lever to gently rotate the new needle as needed so it faces directly forward.
5. Secure the needle
Hold upward pressure and gently hand-tighten, then use your wrench to firmly secure the clamp screw. Be careful not to overtighten.
Check Your Needle
Verify your checklist:
- The needle is inserted all the way up and visible through the sight hole.
- The needle has the long groove facing forward.
- The clamp screw is tightened and the needle is secure.
Give the needle a gentle downward tug. It should stay firmly in place.
That's it. Your needle is fresh and ready. Check out our other Handi Quilter videos to learn more.