Changing the Foot

Changing your hopping foot lets you choose the right foot for the job, and it only takes a minute. Here's how.

Before You Begin

Before you begin, press the Needle Up/Down button to raise the needle.

What You'll Need

Grab the hex wrench that came with your machine and the foot you want to use.

  • 2.5 mm hex wrench
  • Hopping foot

Change Your Foot

1. Remove the current foot

Use the hex wrench to loosen the mounting screw on the side of the foot. Loosen it just enough to slide the foot down and off. There's no need to take the screw all the way out.

2. Attach the new foot

Slide the new foot onto the mount, lining up the opening on the side of the foot with the screw. Push it up as far as it will go.

3. Tighten and check

Hold the foot in place, applying upward pressure, and tighten the screw firmly with the hex wrench.

Take a quick look from the front. The needle should sit centered in the foot's opening.

4. Test it

Scroll the on-screen handwheel to watch the needle pass cleanly through the foot.

Done. Your new foot is on, and you're ready to quilt.