Bobbin Basics
Let's load your bobbin case, check the tension, do a quick clean and oil, and put it in your machine.
Before You Begin
First, press the Needle Up/Down button to raise the needle. Then turn off your machine.
What You'll Need
You'll need a wound bobbin, your bobbin case, the screwdriver that came with your machine, a lint brush, and sewing machine oil.
- Wound bobbin
- Bobbin case
- Screwdriver
- Lint brush
- Sewing machine oil
Load, Check, Oil, Install
1. Load the bobbin into the case
Start by holding the bobbin case with the open side facing you. Drop the bobbin in so the thread will unwind clockwise.
Slide the thread through the slot and under the tension spring, leaving a five- to six-inch tail. Give the thread a tug. The bobbin should turn clockwise.
2. Check and adjust bobbin tension
Next, check the tension. Rest the case in your palm and gently lift the thread.
- Too tight: the case lifts right off your hand.
- Too loose: the case stays flat.
To adjust, turn the larger screw: clockwise to tighten, counterclockwise to loosen. A tiny turn goes a long way, so adjust a little and test again.
Your tension is just right when the case stands up in your hand, but doesn't leave your hand.
3. Clean and oil
Anytime you change your bobbin, brush away any lint and add one small drop of oil to the bobbin race — that's the track where the bobbin case sits.
4. Insert the bobbin case into the machine
Finally, with the slot facing up, push the bobbin case in until it clicks.
And you're done! Your bobbin is in and ready to quilt.